Catalyst 4948 problem Boot Auto Romon

Catalyst 4948 problem Boot Auto Romon

  September 30, 2019    saeful's ScremOo

---

Hi,

Hourreey !!!

It is impossible to manually set a value to the register. The only way is to use the command confreg.

So, I didn't see the statement " 1 = the first file from internal flash device" but with your help, it works fine now.

Many thanks for your help.

rommon 1 >confreg

Configuration Summary :
=> load rom after netboot fails
=> console baud: 9600
=> autoboot from: commands specified in 'BOOT' environment variable

do you wish to change the configuration? y/n  [n]:  y
enable  "diagnostic mode"? y/n  [n]:  n
enable  "use net in IP bcast address"? y/n  [n]:  n
disable "load rom after netboot fails"? y/n  [n]:  n
enable  "use all zero broadcast"? y/n  [n]:  n
enable  "break/abort has effect"? y/n  [n]:  n
enable  "ignore system config info"? y/n  [n]:  n

change console baud rate? y/n  [n]:  n

change the boot characteristics? y/n  [n]:  y

enter to boot:
0 = disable autoboot
1 = the first file from internal flash device
2 = commands specified in 'BOOT' environment variable
[2]:  1

Configuration Summary :
=> load rom after netboot fails
=> console baud: 9600
=> autoboot from: the first file from internal flash device

do you wish to save this configuration? y/n  [n]:  y
You must reset or power cycle for new configuration to take effect

Regards..

Saefuls